Specifications To be installed and/or used in accordance with appropriate electrical codes and regulations. To install: ·Warning:To avoid fire,shock,or death.Turn off power at circuit breaker or fuse and test that power is off before wiring! ·Caution:Use these devices only with copper or copper clad wire.With aluminum wire,use only devices marked CO/ALR. ·Caution:When installing these devices,a neutral wire is required for the outlet and pilot light portions.When only one black and one white wire are present in the wall box,the white wire is not necessarily a neutral wire.If you are unsure or unable to determine the polarity of the two wires,consult a qualified electrician.
Do not use to replace a switch that had been controlling a light with only two wires present.
Caution:Without use the nightlight during night,turn the small swith to OFF position . 1.Remove approximately 5/8"（1.6cm）insulation from wire. 2.Connect wires per corresponding diagram as follows:Loop wires clockwise 3/4 turn around terminal screws.Tighten screws over wire loops with a force of 12-14in-lib.of torque.Terminal screws accept up to 14AWG copper or copper clad wire. 3.Attach wallplate and restore power.Installation is complete.
Common Feed:A single pole switch in the circuit to control a independent light.
